Appendix A - Dell Powerconnect Arubaos & Awms Cli Commands - Dell PowerConnect W-Airwave Manual

Appendix A - Dell PowerConnect ArubaOS & AWMS CLI
Commands
Enable Stats Utilizing the Dell PowerConnect W CLI (Local
Controller in Master Local Environment)
Note : Do not use these commands if using the Dell PowerConnect W AWMS WebUI to set these commands.
SSH into the controller, and enter "enable" mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # wms general collect-stats enable
(Controller-Name) (config) # write mem
Saving Configuration...
Saved Configuration
Offload WMS Utilizing Dell PowerConnect ArubaOS CLI and
AWMS CLI (SNMP Walk)
Note : Do not use these commands if using the Dell PowerConnect W AWMS WebUI.
Dell PowerConnect W CLI
SSH into all controllers (local and master), and enter "enable" mode, and issue the following
commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mobility-manager <AMP IP> user <MMS-USER> <MMS-
SNMP-PASSWORD> trap-version 2c (trap-version was added in 3.3.2.14 to prevent
the SNMPv3 inform queue overflow on the controller)
This command creates an SNMPv3 user on the controller with authentication protocol configured to
SHA and privacy protocol DES. The user and password must be at least eight characters, because the
Net-SNMP package in Dell PowerConnect W AWMS adheres to this IETF recommendation.
DellPowerConnect W automatically creates Auth and Privacy passwords from this single password. If
mobility-manager is already using a preconfigured SNMPv3 user ensure the Privacy & Authentication
passwords are the same. This command also creates the AWMS server as an SNMPv3 Trap Host in the
controller's running configuration
Sample: mobility-manager 10.2.32.1 user airwave123 airwave123
(Controller-Name) (config) # write mem
Saving Configuration...
Saved Configuration
Dell PowerConnect W AWMS SNMP
Login into the AMWS server with proper administrative access and issue the following command for all
controllers (master and locals):