Fujitsu BX600 User Manual page 54

Message
Number
7
8
9
10
11
12
13
14
154
Message
Could not bind to
adapter.
Successfully bind to
adapter.
Network adapter is
disconnected.
Network adapter is
connected.
Broadcom Advanced
Program Features Driver
is not designed to run on
this version of Operating
System.
Hot-standby adapter is
selected as the primary
adapter for a team
without a load balancing
adapter.
Network adapter does
not support Advanced
Failover.
Network adapter is
enabled via management
interface.
Cause
The driver could not
open one of the team
physical adapters.
The driver successfully
opened the physical
adapter.
The physical adapter is
not connected to the
network (it has not
established link).
The physical adapter is
connected to the network
(it has established link).
The driver does not
support the operating
system on which it is
installed.
A standby adapter has
been activated.
The physical adapter
does not support the
Broadcom NIC
Extension (NICE).
The driver has
successfully enabled a
physical adapter through
the management
interface.
Corrective Action
Unload and reload the
physical adapter driver,
install an updated
physical adapter driver,
or replace the physical
adapter.
Informational message
only.
No action is required.
Check that the network
cable is connected,
verify that the network
cable is the right type,
and verify that the link
partner (switch or hub) is
working correctly.
Informational message
only.
No action is required.
Consult the driver
release notes and install
the driver on a supported
operating system or
update the driver.
Replace the failed
physical adapter.
Replace the adapter with
one that does support
NICE.
Informational message
only.
No action is required.