Event Log Messages - Fujitsu BX600 User Manual

4.9

Event Log Messages

4.9.1 Windows System Event Log messages
The known base and intermediate Windows System Event Log status messages for this product are
listed in "4.9.2 Base Driver (Physical Adapter/Miniport)" ( pg.151) and "4.9.3 Intermediate Driver
(Virtual Adapter/Team)" ( pg.153). As a Broadcom adapter driver loads, Windows places a status
code in the system event viewer. There may be up to two classes of entries for these event codes
depending on whether both drivers are loaded (one set for the base or miniport driver and one set for
the intermediate or teaming driver).
4.9.2 Base Driver (Physical Adapter/Miniport)
"• Base Driver Event Log Messages" ( pg.151) lists the event log messages supported by the base
driver, explains the cause for the message, and provides the recommended action.
• Base Driver Event Log Messages
Message
Number
1 Failed to allocate memory
for the device block.
Check system memory
resource usage.
2 Failed to allocate map
registers.
3 Failed to access
configuration information.
Reinstall the network
driver.
4 The network link is down.
Check to make sure the
network cable is properly
connected.
5 The network link is up.
6 Network controller
configured for 10Mb half-
duplex link.
Message
The driver cannot allocate
memory from the
operating system.
The driver cannot allocate
map registers from the
operating system.
The driver cannot access
PCI configuration space
registers on the adapter.
The adapter has lost its
connection with its link
partner.
The adapter has
established a link.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
Cause Corrective Action
Close running applications
to free memory.
Unload other drivers that
may allocate map
registers.
For add-in adapters: reseat
the adapter in the slot,
move the adapter to
another PCI slot, or
replace the adapter.
Check that the network
cable is connected, verify
that the network cable is
the right type, and verify
that the link partner (for
example, switch or hub) is
working correctly.
Informational message
only.
No action is required.
Informational message
only.
No action is required.
4 Broadcom Gigabit Ethernet Teaming Services
E
151