8.
To install a memory module, slide the SODIMM into the socket at approximately a 30° angle (1),
then press the SODIMM down (2) so that the latches lock it in place.
Figure 2-28
NOTE:
with the tab on the memory socket.
9.
To replace the access panel, set the panel on the back of the computer, slightly above the stand,
and slide it down into place.
Figure 2-29
10.
Reconnect the power cord and external devices.
11.
Lock any security devices that were disengaged when the access panel was removed.
12.
Place the computer in the upright position.
13.
Turn on the computer. The computer automatically recognizes the additional memory when you
turn on the computer.
32
Chapter 2 Hardware repair and upgrade
Installing a memory module
A memory module can be installed in only one way. Match the notch on the module
Replacing the access panel