11.
If installing a USB 3.0 media card reader, connect the USB cable from the media card reader to
the USB 3.0 connector on the system board labeled MEDIA3.0.
NOTE:
drive connectors.
12.
Rotate the drive cage back down to its normal position.
CAUTION:
13.
Replace the front bezel.
14.
Replace the computer access panel.
15.
If the computer was on a stand, replace the stand.
16.
Reconnect the power cord and any external devices, then turn on the computer.
17.
Lock any security devices that were disengaged when the access panel was removed.
ENWW
Refer to
System board connections on page 64
Be careful not to pinch any cables or wires when rotating the drive cage down.
for an illustration of the system board
Installing and removing drives
79