Installing Additional Memory; Dimms; Ddr3-Sdram Dimms - HP EliteDesk 800 Hardware Reference Manual

No. System Board Connector
17 DIMM4 (Channel A)
18 DIMM3 (Channel A)
19 DIMM2 (Channel B)
20 DIMM1 (Channel B)
21 Power
22 Power
23 USB 3.0
24 USB 3.0
25 SATA 3.0
26 SATA 3.0

Installing additional memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-
SDRAM) dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs.
These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum
memory support, you can populate the system board with up to 32-GB of memory configured in a
high-performing dual channel mode.

DDR3-SDRAM DIMMs

For proper system operation, the DDR3-SDRAM DIMMs must be:
●
industry-standard 240-pin
●
unbuffered non-ECC PC3-12800 DDR3-1600 MHz-compliant
●
1.35 volt or 1.5 volt DDR3/DDR3L-SDRAM DIMMs
The DDR3-SDRAM DIMMs must also:
●
support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)
●
contain the mandatory JEDEC SPD information
ENWW
System Board Label Color
DIMM4 white
DIMM3 black
DIMM2 white
DIMM1 black
SATA PWR0 black
PWR white
FRONT USB3.0 blue
MEDIA3.0 black
SATA3 light blue
SATA5 light blue
Component
Memory Module
Memory Module
Memory Module
Memory Module
SATA Drives
System Board
Front USB 3.0 Ports
USB 3.0 Device, such as a USB 3.0
Media Card Reader
Any SATA Device other than the
Primary Hard Drive
Any SATA Device other than the
Primary Hard Drive
Installing additional memory 21