HP EliteDesk 800 Hardware Reference Manual page 124

12. Position the hard drive so that the top of the hard drive is up against the top of the carrier (1) so
that the circuit board on the bottom of the hard drive does not come in contact with the tabs on
the bottom of the carrier, then slide the new hard drive into the carrier (2).
CAUTION:
tabs on the bottom of the carrier when sliding the hard drive into the carrier. Doing so can cause
irreparable damage to the hard drive.
13. Set the hard drive down into the bottom of the carrier (1), then replace the four guide screws on
the sides of the carrier to secure the drive in the carrier (2).
116 Chapter 4 Ultra-slim Desktop (USDT) hardware upgrades
Do not allow the circuit board on the bottom of the hard drive to scrape along the
ENWW