9.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
10.
Connect the opposite end of the data cable to one of the light blue SATA connectors on the
system board.
NOTE:
drive connectors.
11.
Replace the front bezel.
NOTE:
from HP. Install the bezel trim piece in the front bezel before replacing the front bezel.
12.
Replace the computer access panel.
13.
Reconnect the power cord and any external devices, then turn on the computer.
14.
Lock any security devices that were disengaged when the access panel was removed.
ENWW
Refer to
System board connections on page 20
An optional bezel trim piece that surrounds the front of the 5.25-inch drive is available
for an illustration of the system board
Installing and removing drives
35