Printing Received Faxes - Brother MFC-J4410DW Basic User's Manual

Printing Received Faxes

Difficulty
 Condensed print
Horizontal streaks

 Top and bottom sentences are
cut off
 Missing lines
Vertical black lines when receiving. The sender's scanner may be dirty. Ask the sender to make a copy to see if the
Left and right margins are cut off or
a single page is printed on two
pages.
Received color fax prints only in
black & white.
Telephone Line or Connections
Difficulty
Dialing does not work.
(No dial tone)
The machine does not answer
when called.
108
Suggestions
Usually this is caused by a poor telephone connection. Make a copy; if your copy
looks good, you probably had a bad connection, with static or interference on the
telephone line. Ask the other party to send the fax again.
problem is with the sending machine. Try receiving from another fax machine.
If the received faxes are divided and printed on two pages or if you get an extra
blank page, your paper size setting may not be correct for the paper you are using.
(MFC-J4410DW: See Paper Size on page 27.)
(MFC-J4610DW: See Paper Size and Type (MFC-J4610DW) on page 28.)
Turn on Auto Reduction. (See Advanced User's Guide: Printing a reduced
incoming fax.)
Replace the color ink cartridges that have reached the end of their life, and then
ask the other person to send the color fax again.
(See Replacing the ink cartridges on page 74.)
Suggestions
Check all line cord connections. Make sure the telephone line cord is plugged into
the telephone wall jack and the LINE jack inside the machine.
(Canada only) Change the Tone/Pulse setting. (See Quick Setup Guide.)
Send a manual fax by pressing Hook and dialing the number. Wait to hear fax
receiving tones before pressing Fax Start.
If there is no dial tone, connect a known working telephone and telephone line cord
to the jack. Then lift the external telephone's handset and listen for a dial tone. If
there is still no dial tone, ask your telephone company to check the line and wall
jack.
Make sure the machine is in the correct Receive Mode for your setup.
(See Choose the correct Receive Mode on page 41.) Check for a dial tone. If
possible, call your machine to hear it answer. If there is still no answer, make sure
the telephone line cord is plugged into the telephone wall jack and the LINE jack
inside the machine. If there is no ringing when you call your machine, ask your
telephone company to check the line.