Table of Contents
Advertisement
4. Adhere the power-adapter port cable on the system board.
5. Align the screw holes on the power-adapter port bracket to the screw holes on the system board.
6. Replace the two screws (M2x4) that secure the power-adapter port bracket to the system board.
7. Replace the system board Mylar back to the edge of the left fan.
8. Route the display cable through the opening between the power-adapter port and the heat-sink assembly.
9. Connect the display cable on the system board and close the latch to secure the cable.
10. Connect the Alienhead LED cable to the system board.
11. Adhere the display cable to the system board.
Next steps
1. Install the
rear
I/O-cover.
2. Install the
base
cover.
3. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
rear
I/O-cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
47
Advertisement
Table of Contents
