Table of Contents
Advertisement
Installation of Adapter Kit 46-00911
1.
Remove the rubber feet on the bottom of the MS7580.
2.
Attach the adapter plate to the bottom of the imager with the four
M3 x .5 x 10 mm screws ( ) provided in the kit.
3.
Attach the base plate to the adapter plate with the four M3 x .5 x 8 mm
screws ( ) provided in the kit.
4.
Before mounting the locking plate, consider the position the imager will rest
when fully installed. There are two tabs located on the locking plate.
These tabs indicate the two directions the imager may face when locked
into position (see figure below).
14
Figure 11
Figure 12
Hide quick links:
Advertisement
Table of Contents
