Table of Contents
Advertisement
RS485
1.
Turn off power to the host device.
2.
Plug the interface cable's modular
connector into the socket on the imager.
3.
Connect the other end of the cable to
proper COM port of the host device
4.
Turn on power to the host device.
5.
The MS7580 will start to initialize.
The white and blue LED will alternately
fade on and off for three seconds.
When the imager has finished
initializing, the imager will flash the white
LED three times while simultaneously
beeping three times. The low intensity
blue LED will remain turned on.
Installation Note
Plugging the imager into a port on the host system does not guarantee that
scanned information will be communicated properly to the host system.
The imager is shipped from the factory configured with default settings.
Please refer to the MetroSelect Single-Line Configuration Guide (PN 00-02544)
or MetroSet2's help files for instructions on changing the imager's configuration.
In addition, please check that the imager and host system are using the same
communication protocol.
The MS7580 requires 12V power from the host for RS485 operation.
.
Figure 7. RS485
9
Hide quick links:
Advertisement
Table of Contents
