Turning The System On; Inserting/Ejecting A Disc; Inserting The Disc; Removing The Disc - Alpine INE-W940 Owner's Manual

Turning the System On

With the Alpine system, when the ignition key is turned to ACC or ON,
the opening screen will be automatically displayed.
1
When the system is used for the first time, the
language selection menu is displayed. There are 24
languages to choose from. Touch [
scroll the list, and then touch the desired language.
• You can also scroll through lists by touching the screen and
sliding your finger up and down.
2
Touch [OK].
The radio screen is displayed.
• Some of this unit's functions cannot be performed while the vehicle is
in motion. Be sure to stop your vehicle in a safe location and apply
the parking brake before attempting these operations.

Inserting/Ejecting a Disc

Inserting the Disc

Insert the disc with the label side facing up.
When you insert the disc up to certain point, it is automatically
pulled into the unit. The unit starts to play the disc.
• Do not touch the surface of the disc directly with your fingers.
• Before inserting or removing the disc, always turn the ignition key to
ACC or ON. You cannot remove or insert the disc with the ignition
key turned to OFF.

Removing the Disc

Press (Eject button).
When the disc has been ejected part way, take it out.
If the disc cannot be ejected by pressing
again for at least 5 seconds.

Adjusting the Volume

Adjust the volume by pressing
Volume decreases/increases continuously by pressing and
holding
Volume: 0 - 35
] or [ ] to

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
1
2
Top banner and Bottom banner Fade Out
Setting
When "Top/Bottom Banner Fade Out" is set to "ON," the Top banner
and Bottom banner on the Audio/Visual Playback screen fade out after 5
seconds if no operation is performed. To display the keys again, touch
the middle of the screen.
Disc Slot
• For details of how to set Top/Bottom Banner Fade Out, refer to
"Setting Top banner and Bottom banner Display" (page 31).
, press and hold
or .
Press MUTE button to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE button again will bring the audio
back to its previous level.
Top banner
Bottom banner
or .
15
-EN