Table of Contents
Advertisement
Getting Started
Location of Controls
(Favorite) button
Recalls the Favorite screen.
• Press and hold this button for at least 2 seconds to switch to
the iData Link mode screen.
(MUTE) button
Press to activate/deactivate the mute mode.
(AUDIO)/ (Voice Recognition mode) button
Displays the Audio/Visual screen. If the Audio/Visual screen is
already displayed, changes the source.
When a hands-free phone with Voice Recognition is connected,
press and hold for at least 2 seconds to switch to the Voice
Recognition mode.
/
(UP/DOWN) button
Press to adjust the volume.
RESET switch
The system of this unit is reset.
(Eject) button
Ejects a disc.
MENU/ (Power Off) button
Recalls the Menu screen.
Press and hold this button for at least 5 seconds to turn the
power off.
(NAV) button
Recalls the navigation map screen.
Press again to switch to Navigation menu screen.
Press and hold this button for at least 2 seconds to change to Go
Home route screen. (If Home is not set yet, it will change to the
Home setting screen.)
For details of navigation operations, refer to "Navigation System
OM" in the website at http://www.alpine-usa.com.
/
button
Press to seek up/down a station in radio mode or up/down a
track, chapter, etc., in other audio/visual sources.
Remote Sensor
Point the remote control transmitter towards the remote sensor
within a range of 2 meters.
14
-EN
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote control sensor.
About the button descriptions used in this Owner's
Manual
The buttons found on the face of the unit are expressed in bold
(e.g. MENU). The buttons found on the touch-screen display are
shown in bold within brackets, [ ] (e.g. [
Turning Power On or Off
Some of this unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Turn the ignition key to the ACC or ON position.
The system turns on.
• When turned on, the system displays the last screen that was
displayed before the ignition key was turned off. For example, if
the unit is in radio mode when ignition is turned off, it will remain
in radio mode when ignition is turned back on.
2
Press and hold the MENU/ (Power Off) button for at least
5 seconds to turn the power off.
• The unit can be turned on by pressing any button.
• The unit is a precision device. Careful handling of the unit should
provide you with years of trouble-free operation.
Turning the System On
With the Alpine system, when the ignition key is turned to ACC or ON,
the opening screen will be automatically displayed.
When the system is used for the first time, the language
selection menu is displayed. Swipe the Language list screen
vertically, then touch your choice from the list of 23
languages.
• Some of this unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake before attempting these operations.
]).
Advertisement
Table of Contents
