Troubleshooting; Error Messages And Responses - FujiFilm 3000 User Manual

TROUBLESHOOTING

ERROR MESSAGES AND RESPONSES

If an error message appears on the display, follow the responses outlined below. If the printer
fails to function properly even after corrective action has been taken, contact the dealer from
whom you purchased your PosterPrinter 3000.
Error Message Description
The original has not been detected
by the scanner within the
programmed time period.
The original has jammed in the
scanning unit.
The scanner cover is open.
The printer cover is open.
The paper has not been installed.
The paper has not been loaded
correctly.
The thermal heads have
overheated.
When the power is turned on, or
after an error has occurred, the
shuttle unit has not moved back
into home position.
There is some sort of failure with
the printer.
Response
Press the start/stop key to revert
to the initial screen. Reset the
original and press the start/stop
key again.
Open the scanner cover and
remove the input document.
Firmly close the scanner cover.
Firmly close the printer cover.
Install a paper roll.
Reload the paper roll.
Turn the power off, wait for at
least three minutes, and then turn
the printer on again.
Turn the power off, clean the
shuttle shaft, and gently move the
shuttle unit into home position
(on the right of the printer) with
your hands. Turn the printer on
again.
Turn the power off and then on
again.
If the printer fails to function
properly even after corrective
action has been taken, contact
the dealer from whom you
purchased your PosterPrinter
3000. Be sure to tell your dealer
which of the error messages was
displayed.
9
29