Loading The Smartmedia; Removing The Smartmedia - FujiFilm FinePix4800Zoom Owner's Manual

LOADING THE SmartMedia

SmartMedia ™
I Only use 3.3V SmartMedia
MG-4S ( 4MB), MG-16SW ( 16MB, ID)
MG-8S ( 8MB), MG-32SW ( 32MB, ID)
MG-16S (16MB), MG-64SW ( 64MB, ID)
MG-32S (32MB), MG-128SW (128MB, ID)
MG-64S (64MB)
G
!
Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
G
!
Operation of this camera is only guaranteed when it
is used with FUJIFILM SmartMedia.
G
!
Some 3.3V SmartMedia are labelled as "3V" or "ID"
cards.
G
20 !
See P.115 for more information on SmartMedia.
™
G
➀
G
➁
➀
Check that the camera is switched off and
open the slot cover.
➁
Push the SmartMedia firmly into the SmartMedia
slot as far as it will go.
➂
Close the slot cover.
G
!
If you open the slot cover while the camera is
switched on, the camera is automatically switched
off to protect the SmartMedia.
G
!
The SmartMedia will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to
apply undue force to the SmartMedia.

REMOVING THE SmartMedia

G G
➂ ➀
1
➀
Check that the indicator in the viewfinder is
green and then switch the camera off.
➁
Release the SmartMedia cover lock as shown
in the figure.
G
!
See P.22 for information on switching the camera on
and off.
Never open the SmartMedia slot cover while
the camera is switched on.This could destroy
the image data or damage the SmartMedia
itself.
™
G
➁
2
Push the SmartMedia into the slot slightly and
allow it to pop back out. It can then be pulled out
easily.
G
!
To protect the SmartMedia, always store it in the
special anti-static case.
N
Printing Images and
Downloading Images to a PC
G
See P.85, 108 for information on printing
images.
G See P.101 – 108 for information on downloading
images to a PC.
1
N
21