FujiFilm FinePix4800Zoom Owner's Manual page 62

Troubleshooting
Problem
Can't format the • The SmartMedia is write-protected.
SmartMedia.
The ERASE ALL function • The frame is protected.
does not erase all the
frames.
Nothing happens when I • Camera malfunction.
use the camera switches
and dial. • The Mode switch and Mode dial has been
moved to another setting.
• The battery is exhausted.
No image appears when I • The Mode switch and Mode dial has been
press the "DISP" button. moved to another setting.
The camera does not • The camera volume is set too low.
emit any sound. • The microphone was blocked during
shooting/recording.
• The speaker was blocked during
playback.
• The A/V cable is connected.
There is no picture on • The camera and TV are connected
the TV. incorrectly.
• The TV input is set to "TV".
122
Cause Remedy
• Remove the write-protection.
(Peel off the write-protect sticker.)
• Remove the frame protection.
• Remove the battery, re-insert them and
try again.
• Set the Mode switch and Mode dial to the
correct setting.
• Load a new fully charged battery.
• Set the Mode switch and Mode dial to the
correct setting.
• Adjust the volume.
• Take care not to block the microphone
during shooting/recording.
• Take care not to block the speaker during
playback.
• Disconnect the A/V cable.
• Connect the TV and camera correctly.
• Set the TV input to "Video".
Problem Cause
• The camera and cradle are not connected
PC connection failed.
correctly.
• The USB cable is not connected to the
cradle correctly.
• The camera and USB cable are not set up
correctly.
• The PC is not switched on.
The lens extends during • The camera and cradle are not connected
card reader connection. correctly.
• The PC is not switched on.
I tried to charge the • There is no battery in the camera.
battery but the self-timer • The camera and cradle are not connected
lamp does not light. correctly.
• The cradle and AC power adapter are not
connected correctly.
The self-timer lamp blinks • The battery is old.
during battery charging.
The camera no longer • The camera has suffered an unforeseen
works correctly. problem.
Remedy
• Connect the camera and cradle correctly.
• Ensure that the USB cable is properly
connected to the cradle.
• Set up the camera and USB cable
correctly.
• Switch the PC on.
• Connect the camera and cradle correctly.
• Switch the PC on.
• Load the battery.
• Connect the camera and cradle correctly.
• Connect the cradle and AC power adapter
correctly.
• Install a new battery.
• Remove the battery briefly and then
reload the battery and try again.
123