Delete Saved Remote Control Codes - Marantz SR7008 Owner's Manual

Contents
5
Press and hold the button that you want to register on
the other remote control until "OK" is displayed on the
Marantz remote control display.
• If "NG" is shown on the remote control display, perform step 4
again.
6
Repeat steps 4 and 5 to learn other buttons for the same
input source.
7
When programming of the remote control unit is
completed, press SET.
The LEARN indicator turns off, and the remote control unit exits
learn mode.
%
• There are some remote control units that cannot be programmed, or even if they
can be programmed, they may not operate correctly. If this happens, use the
remote control unit supplied with the AV equipment to operate it.
• If the remote control memory becomes full, "FULL" is shown on the remote control
display. If you want to learn the code, you should erase other learned button.
NOTE
• The learning function is unavailable for all ZONE SELECT, SET, AVR, POWER
X, VOLUME df, FAVORITE STATION, SOUND MODE and input source select
buttons in any mode.
• If no buttons are pressed for approximately 1 minutes while in the LEARN mode,
the remote control unit automatically exits from the LEARN mode.
Front panel Display
Connections Playback
Rear panel
Settings

Delete saved remote control codes

Codes can be erased in three ways: by buttons, sources, and by all
memory contents.
2 Delete remote control codes for each button
1
Press and hold SET until the LEARN indicator blinks.
2
Press input source select buttons to select the input
source you want to delete.
The input source is shown in the remote control display.
3
Press and hold POWER X and press the learned button
to be erased twice.
"ERASE" is shown in the remote control display.
4
Press SET.
• The LEARN indicator turn off.
221
Remote
Tips Appendix
Index