Bass; Impedance; Front Speaker - Marantz SR7008 Owner's Manual

Contents

Bass

Set subwoofer and LFE signal range playback.
2 Subwoofer Mode
Select low range signals to be reproduced by subwoofer.
LFE (Default) : The low range signal of the channel set to "Small"
speaker size is added to the LFE signal output from the
subwoofer.
LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best
setting for most systems.
%
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 194) is set to other than "None".
• Play music or a movie source and select the mode offering the strongest
bass.
• If "Front" and "Center" for "Speaker Config." (vpage 193) are set to
"Large", and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected sound mode.
Select "LFE+Main" if you want the bass signals to always be produced from
the subwoofer.
2 LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
Front panel Display
Connections Playback
Rear panel
Settings

Impedance

Set the impedance of connected speakers.
8Ω/ohms (Default) : Select when the impedance per speaker for all the
connected speakers is 8 Ω/ohms or larger.
6Ω/ohms : Select when the impedance for any of the connected speakers
is between 6 Ω/ohms and 8 Ω/ohms.
%
• Check the speaker impedance (Ω/ohms) shown on the back of your speakers or in
the instruction manual beforehand.

Front Speaker

Set the front speaker A/B to use for every sound mode.
%
• This can be set when "Assign Mode" (vpage 192) is set to "7.1ch + Front B".
A (Default) : Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
%
• This can be set by pressing SPKR A/B on the main unit.
198
Remote
Tips Appendix
Index