Input Select - Marantz SR7008 Owner's Manual

Contents

Input Select

Set the audio input mode and decode mode of each input source.
The input modes available for selection may vary depending on the input
source.
2 Input Mode
Set the audio input modes for input sources.
It is normally recommended to set the audio input mode to "Auto".
Auto (Default) : Automatically detect input signal and perform playback.
HDMI : Play only signals from HDMI input.
Digital : Play only signals from digital input.
Analog : Play only signals from analog input.
7.1CH IN : Only signals input from the 7.1CH IN connector will be
played back.
%
• When digital signals are properly input, the
~
If the indicator does not light, check "Input Assign" (vpage 179) and
the connections.
• If "HDMI Control" is set to "On" and a TV compatible with the ARC is
connected via the HDMI MONITOR connectors, the input mode whose input
source is "TV AUDIO" is fixed to ARC.
• The sound mode cannot be set if the input mode is set to "7.1CH IN".
Front panel Display
Connections Playback
~
indicator lights on the display.
Rear panel
Settings
2 Decode Mode
Set the audio decode mode for input source.
Auto (Default) : Detect type of digital input signal and decode and play
automatically.
PCM : Decode and play only PCM input signals.
DTS : Decode and play only DTS input signals.
%
• This item can be set for input sources for which "HDMI" or "DIGITAL" is
assigned at "Input Assign" (vpage 179).
• Normally set this mode to "Auto". It is recommended to set "PCM" or "DTS"
when audio is missing at the beginning or a noise occurs.
182
Remote
Tips Appendix
Index