Installing A Server Module; Opening And Closing The Server Module; Opening The Server Module - Dell PowerEdge VRTX Owner's Manual

1. release button
2. PCIe label on server module
NOTE: This label indicates that the
server module is configured specifically
for the VRTX enclosure.

Installing A Server Module

1. If you are installing a new server module, remove the plastic cover from the I/O connector(s) and save for future
use.
2. Orient the server module so that the module handle is on the left side of the server module.
3. Slide the server module into the enclosure until the module release handle engages and locks the server module in
place.
4. Reinstall the front bezel.

Opening And Closing The Server Module

Opening The Server Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the
interior of the system.
1. Remove the server module from the enclosure.
2. Install the I/O connector cover.
3. Press the release button and slide the cover toward the back of the server module.
4. Carefully lift the cover away from the server module.
3. guide rail on server module (or server module
blank)
4. guide rail on enclosure
5. server module handle
27