Installing A Server Module - Dell 1955 Hardware Owner's Manual

Installing a Server Module

NOTICE:
Follow this procedure carefully—it is possible to insert the server module upside-down, which may
damage the chassis midplane and the server module.
1 Orient the server module so that its top side is up. The server module is correctly oriented for
installation when its components have the characteristics described below:
The server module's upper handle is above (outside) the lower handle.
a
The upper handle has the DELL logo™ on it, extends farther out than the lower handle, and has a
release latch on its inside. See Figure 3-12.
The upper edge of the server module has "TOP-SIDE" engraved in it. See Figure 3-12.
b
Figure 3-12. Proper Server Module Installation Orientation
6
5
1 upper handle
4 lower handle
2 Slide the server module into the chassis until the open handles touch the front panel of the chassis.
3 Rotate both handles inward until the lower handle is flush against the server module's front panel.
The lower handle automatically closes before the upper handle.
74
Installing System Options
1
4
2 "TOP-SIDE" engraved in server
module
5 logo
2
3
3 server module
6 release latch inside of upper
handle