Table of Contents
Advertisement
H
ARDWARE
1. Select the Site – Choose a location for your SMC2682W Wireless
Access Point/Bridge. Usually the best place is at the center of your
wireless coverage area, within line-of-sight of all wireless devices. Try
to place the AP/Bridge in a position that can best cover its BSS (refer
to page 25). Normally, the higher you place the antenna, the better the
performance (see page 31 for the maximum distances allowed between
clients and the AP/Bridge.)
2. Attach the Antenna – Screw the antenna into the antenna connector
on the back panel.
3. Connect the Ethernet Cable – The 10BASE-T Ethernet port on the
AP/Bridge can be connected to a network device such as a hub or a
switch. Connect Category 3, 4, or 5 UTP Ethernet cable to the RJ-45
socket on the back panel.
4. Connect the Power Cable – Connect the power adapter cable to the
9 VDC power socket on the rear panel.
Warning: Use ONLY the power adapter supplied with the SMC2682W.
I
RJ-45
Connector
Antenna
Connector
Reset
Button
NSTALLATION
RS-232 Port
DC 9V
Power Cable
7
Advertisement
Table of Contents
