Automatic Exposure Adjustment - Sharp AL-1611 Operation Manual

AUTOMATIC EXPOSURE ADJUSTMENT

The automatic exposure level can be adjusted to suit your copying needs.
This level is set for copying from the original table and copying from the
SPF (AL-1622 only) respectively. To set the level for the SPF, place an
original in the document feeder tray and make sure that the SPF indicator
lights up before proceeding to step 1. To set the level for the original table,
ensure that the SPF indicator does not light up.
Press the AUTO/MANUAL/PHOTO key to select the
1
PHOTO mode.
Press and hold down the AUTO/MANUAL/PHOTO key
2
for approximately 5 seconds.
G
The PHOTO indicator will go out and the AUTO indicator will begin
to blink.
G
One or two exposure indicators corresponding to the current automatic
exposure level will light up. The factory default setting is level "3".
Press the light (
3
the automatic exposure level as desired.
Press the AUTO/MANUAL/PHOTO key.
4
G
The AUTO indicator will stop blinking and will light up steadily.
G
This automatic exposure level will remain in effect until you change
it again by this procedure.
) or dark ( ) key to lighten or darken
31