Table of Contents
Advertisement
TD CARTRIDGE REPLACEMENT
If the machine detects an insufficient amount of toner available, it will stop
copying but will continue to run while feeding toner. During this time the
TD cartridge replacement required (
key indicator will go out. When sufficient toner has been added, the blinking
indicator will go out and the START key indicator will light up indicating
that copying can be resumed. However, if toner addition continued for a
maximum of two minutes, the TD cartridge replacement required (
indicator will light up steadily in addition to the START key indicator
lighting. This indicates that the toner supply is low and that a new TD
cartridge will be needed soon. If copying is continued in this state, the copies
will gradually become lighter until the copier stops and the TD cartridge
replacement required (
) indicator begins to blink, indicating that the
cartridge must be replaced before copying can be resumed. Replace the TD
cartridge by following the procedure below.
TD cartridge lock
release lever
4 or 5 times
) indicator will blink and the START
Open the bypass tray. Lift slightly on the side cover and
1
slide the cover out until it stops.
Push gently on both sides of the front cover and open it.
2
Lift the TD cartridge lock release lever and pull the
3
cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
G
Dispose of the old TD cartridge in accordance with local regulations.
Remove the new TD cartridge from the bag. Hold the
4
cartridge on both sides and shake it horizontally four or
five times.
For best copying results, be sure to use only
SHARP products.
Only genuine SHARP consumables carry the
Genuine Supplies label.
)
GENUINE SUPPLIES
33
Advertisement
Table of Contents
