Sharp AJ-6000 Operation Manual page 16

INSTALLING THE PRINT HEADS AND INK TANKS
Lower the print head latch.
9
Lower the latch until it clicks into the latched position.
Unpack the ink tanks from their protective wrapping and slowly
10
remove the tape.
! Hold the ink tank upright when removing the tape. Do not touch the uncovered
opening on the ink tank, as ink will get on your hands.
! Ensure that there are no pieces of tape remaining on the ink tank.
Turn the ink tanks upside down, and then immediately insert
11
each of them to the print head of corresponding number.
Do not touch this area.
The unit may not copy
if it is dirty.
Ensure the number on each print head corresponds to the number on each ink
tank.
14
Match the ink tank number
to the print head number.
Make sure that each tab
securely locks the ink tank
by pressing here.
Properly align the tab
when inserting the ink ta