Installing The Print Heads And The Ink Tanks - Sharp AJ-6000 Operation Manual

INSTALLING THE PRINT HEADS AND THE INK
TANKS
Follow the steps below to install the print heads and the ink tanks.
This section describes how to install the print heads and ink tanks when you install
them for the first time after purchasing this unit. Refer to "THE INK TANK" (See
page 50) and "THE PRINT HEAD" (See page 52) for the information on replacing
the ink tank or print head in the unit with new ones.
Make sure that the scan head fixing switch is released.
1
Refer to step 3 of "UNPACKING". (See page 9)
Make sure that the power is on.
2
Refer to "OPERATION PANEL PART NAMES AND FUNCTIONS" for detail on how
to turn on the power when you turn on the unit. (See page 23)
Load paper following the steps shown in "LOADING PAPER".
3
(See page 19)
Turn the front cover locking knob with one hand and lift the
4
front cover with the other hand, while keeping the knob in the
unlocked position.
Keep the front cover open securely while installing print heads and ink tanks. You may
get your hand caught between the body and the front cover of the unit if you install
them with the front cover half open as shown in the illustration marked with an "X".
12
Do not move the
carriage manually by
force.