Installing Ft Server Control Software - NEC Express5800/320Fd-LR User Manual

Installing ft Server Control Software

When you install Windows Server 2003 R2, Enterprise x64 Edition with "Manual Setup," or reinstall it
in order to repair ft Server Control Software, take the following procedure to install the ft Server Control
Software.
When you install Windows Server 2003 R2, Enterprise Edition with "Express Setup," ft Server Control
Software is automatically installed; therefore, you do not need to install ft Server Control software with
the following procedure.
IMPORTANT:
Terminate all programs before starting the installation.
You must terminate all programs because the software will not be installed successfully,
especially when Microsoft management console is running.
The LAN settings will be deleted by the installation. Write down the setting information for
making the settings after the installation as necessary.
The dual configuration of LAN needs to be removed before starting the installation.
If it is still set, remove the setting.
When you execute the manual setup of ft Server Control Software or reinstall for a restoration,
you need to follow the procedure in [Chapter 4 Windows Setup] and disable the OS Boot
Monitoring function. After the reinstallation is finished, resume the setting of the OS Boot
Monitoring function to "Enabled."
1.
Follow the steps below to install ft Server Control Software.
a) After logging on to the system as a user with the Administrative account, insert the
"NEC EXPRESSBUILDER" DVD-ROM into the DVD-ROM drive of the server.
b) The menu screen starts up. Click [Setup software] and select [ft Server Control
Software] on the menu.
Follow the instructions to with the installation. The message "ft Server Control Software,
Now Installing... Please Wait." is displayed while ft Server Control Software. Do not use
the keyboard or mouse while this message is being displayed.
2.
The system is rebooted during the installation.
The system is rebooted several times during the installation. Remove the DVD from the
DVD-ROM drive once rebooting is started.
After the system is rebooted, log in again as the user logged in before rebooting. Installation of
the ft Server Control Software is continued.
3.
The message "Installation finished." is displayed.
Once the installation is completed, the message "Installation finished." is displayed and the
Troubleshooting 6-13