NEC Express5800/320Fd-LR User Manual page 105

IMPORTANT:
To perform this procedure, you need to log on as an administrator or a
member of administrator group.
RDR can only be set on the basic disk inserted into the built-in slot of
NEC Express5800/ft series. It cannot be set on the dynamic disk.
For the disk on which RDR is set, use the products with the same serial
number.
Be sure to configure the RDR settings in the same way not only when
the OS is installed but also when the disk is added to the PCI module.
Create partitions only after the duplication of the hard disk drives are
configured.
Follow the steps below to configure the dual disk configuration.
IMPORTANT:
The following describes the dual disk configuration of the slot 1.
If the HDD is mounted to the slot 2 or the slot 3, follow the procedure below to
configure the dual disk configuration likewise.
Insert a new HDD into an internal HDD slot.
1.
IMPORTANT:
If the HDD is already mounted, this procejure is not required. Proceed to Step 2.
Start [Management Tool] by going
2.
to [Start] – [Control Panel], and
select [Disk management on the
left tree. If the disk you want to
duplex is shown as "Not
Initilized," right click on the disk
to initialize.
TIPS:
A popup window is displayed
when you inserted or
initialized the disk; however,
you do not need to restart the
system. Select [No] to exit the
popup window.
Windows Setup 4-41