NEC Express5800/320Fd-LR User Manual page 115

Setup of receiving SNMP packets from specific communities only
Change the name of the community receiving SNMP packets from the default "public"
to any name.
IMPORTANT:
If the community name is changed, you must change the registered community of
NEC ESMPRO Agent from [Control Panel]. To change the community to another
and register it, use the [SNMP Community] list box in the [General] tab.
To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC
ESMPRO Manager, set the send community name in NEC ESMPRO Manager to
be the same as that accepted by the SNMP Service in NEC ESMPRO Agent.
Terminate the network setup.
7.
IMPORTANT:
If the SNMP service is added to the system after the service pack had been applied
at OS installation, apply it again. If not, the SNMP service may not operate
properly. This can cause the improper operation of NEC ESMPRO Agent.
The SNMP Service is required for operating NEC ESMPRO Agent. If the SNMP
Service is deleted after the installation of NEC ESMPRO Agent, install the SNMP
Service and then reinstall NEC ESMPRO Agent.
Some software products provided by other vendors use the SNMP Service. If the
SNMP Service and NEC ESMPRO Agent are installed in the system in which such
software as above is installed, it may be impossible to start NEC ESMPRO Agent
services. If so, delete the SNMP Service once and install the service again. Then,
reinstall NEC ESMPRO Agent and the other vendor's software.
Windows Setup 4-51