Table of Contents
Advertisement
Step 2: Prepare for Express Setup
Before starting Express Setup, be sure to do the following. If these preparations are not done, setup
cannot be performed properly.
2-1: Prepare NEC Express5800/320Fc system
With the power of NEC Express5800/320Fc system off, follow the steps below:
1.
Prepare NEC Express5800/320Fc system.
Mount the modules for both systems.
Insert only one hard disk to the Slot 1 of the CPU/IO module 0.
Remove all LAN cables.
Remove optional SCSI devices such as a tape device from the SCSI connector.
IMPORTANT:
Do not mount any hard disk into any slots of any modules unless specified. If multiple
hard disks are inserted, the hard disk to install OS cannot be determined.
2.
Prepare the installation from the CPU/IO module 0.
The location of the parts required for operations and check are shown below:
CPU/IO module 0
Power LED
CPU/IO module 0
Status LED
CPU/IO module 1
Power LED
CPU/IO module 1
Status LED
CPU/IO module 0
CPU/IO module 0
POWER switch
CPU/IO module 1
CPU/IO module 1
Power switch
Front side of device
Windows Setup 4-7
CPU/IO module 0
DISK
ACCSSS
CPU/IO module 1
DISK ACCESS LED
Advertisement
Table of Contents
