Table of Contents
Advertisement
6-6 Troubleshooting
(c) Select [Stratus Virtual Disk Driver] and then press Enter.
The screen of (a) is displayed again.
(d) Select [Stratus Embedded SAS Adapter] and then press Enter.
(e) When the following screen appears, remove the floppy disk from the floppy disk drive
and press Enter.
Setup will load support for the following mass storage device(s):
Stratus Virtual Disk Driver
Stratus Embedded SAS Adapter
4.
When you start up Recovery Console from Windows Server 2003 CD-ROM, the following
message appears. Press the R key to boot Recovery Console.
This portion of the Setup program prepares Microsoft(R)
Windows(R) to run on your computer.
- To set up Windows now, press ENTER.
- To repair a Windows installation using
- Recovery Console, press R.
- To quit Setup without installing Windows, press F3.
The message shown above does not appear when you have started up the
Recovery Console installed on the system.
5.
Follow the messages on the screen to start up the Recovery Console.
When you restored a damaged file using the Recovery Console, update the
system described in the next section.
If you run the system without restoring files, enable the configuration for OS
Boot Monitoring function. When necessary for system operation, select
[Server] - [Monitoring Configuration] - [OS Boot Monitoring] and set
appropriate time. See "Step 13: Enable OS Boot Monitoring Function" (page
4-40) for details.
Continue the operations by following the messages.
Welcome to Setup.
IMPORTANT:
IMPORTANT:
Advertisement
Table of Contents
