Timer Settings - Ricoh 7025 Operating Instructions Manual

System Settings

Timer Settings

This section describes User Tools in the Timer Settings menu under System Set-
tings.
Default settings are shown in bold type.
❖ Auto Off Timer
2
After a specified period has passed, following job completion, the machine
automatically turns off, in order to conserve energy. This function is called
"Auto Off".
The machine status after the Auto Off operation is referred to as "Off mode",
or "Sleep mode". For the Auto Off Timer, specify the time to elapse before
Auto Off.
The default setting is 1 min.
The time can be set from 1 to 240 minutes, using the number keys.
From "Off mode" or "Sleep mode", the machine is ready to use within 10 sec-
onds.
Auto Off may not work when error messages appear.
❖ Energy Saver Timer
The machine automatically enters Low Power mode automatically after a job
is finished, and the selected time elapsed.
The default setting is 1 min.
The time can be set from 1 to 240 minutes, using the number key.
Energy Saver may not work when error messages appear.
The machine automatically prints any printer data received while in Energy
Saver mode.
❖ System Auto Reset Timer
The System Reset setting automatically switches the screen to that of the func-
tion set in Function Priority when no operations are in progress, or when an
interrupted job is cleared. This setting determines the system reset interval.
The default setting time is On, 60 sec.
The time can be set from 10 to 999 seconds in 1 second increments, using the
number keys.
If you do not make a selection in the User Tools menu within a certain time,
the control panel display returns to the menu shown before the {User
Tools/Counter} key was pressed.
❖ Copier Auto Reset Timer
Specify the time to elapse before copier modes reset.
If [Off] is selected, the machine does not automatically switch to the user code
entry screen.
The default setting time is On, 60 sec.
The time can be set from 10 to 999 seconds, using the number keys.
16