Frymaster Ultimate Electric Series Service & Parts Manual page 9

1.5 Replace Temperature Probe (cont.)
6. Disconnect the wire harness containing the
probe wiring (arrows). It may be necessary
to remove the wire ties.
7. Use a pin-pusher (P/N 806-4855 or P/N 807-
0928—see Section 1.7) to remove the red and
white probe wires from the connector. Note
probe pin location in plug. Pull the probe
wires out of the insulation.
8. Remove the screw(s) securing the probe
bracket to the element. Remove the metal
wraps securing the probe to the element.
9. Remove the probe bracket and the securing
components from the probe bulb and element.
Thread the probe wire through the hole
(arrow) in the tilt plate assembly and remove
the probe.
ULTIMATE ELECTRIC SERIES FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-4
Use a pin-pusher to remove probe wires from
connector (arrows).
Bracket Screw
Probe Bracket
Remove probe bracket screw and bracket to remove
probe.
Pull old probe wire through grommet to remove
probe.
Probe Bulb