Frymaster Ultimate Electric Series Service & Parts Manual page 13

1.6 Replace Heating Element (cont.)
10. When replacing the left element (as viewed
from the rear of the fryer), use the 9-pin
connector, inserting the leads from the
replacement element. Ensure the pin
numbers match the numbers of the defective
element wires. When all pin terminals have
been fully inserted, close the connector by
sliding the halves together until the tabs snap
back into place (reverse procedure in this
section, Step 2). Check wire numbers to
ensure correct wiring of the replacement
element.
When replacing the right element (as viewed
from the rear of the fryer), follow the above
procedure, inserting pin terminals into the
corresponding holes in the 6-pin connector.
11. Connect the connectors, ensuring the latches
lock in place (arrow).
12. Install the temperature probe wires (marked
for re-assembly) in the corresponding pin
locations.
13. Reconnect the element springs. Older models
have turnbuckles (arrow) to allow adjustment
of the spring tension.
14. Place the tilt housing cover over the tilt
housing assembly and secure with screws.
15. Install back covers and secure with screws.
16. Position fryer under exhaust hood.
ULTIMATE ELECTRIC SERIES FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-8
Left Element—
9-Pin Connector
Ensure the connection is complete and the latches
(arrow) are locked in place.
Older units have turnbuckles to adjust spring tension.
Current production models are not adjustable.
Right Element—
6-Pin Connector