Table of Contents
Advertisement
A. Building Selection
The System Parameters pop up (right) (under the Setup menu)
is used to set up the various programmable features of each
entry system. Door strike timing, opener code, maximum call
time, ring count and silence time out are all programmable from
this screen. This screen also has a check box for disabling the
Keyless Entry Codes. This feature is useful when using card readers. By checking this box, a card can be used to gain access, but
trying to enter the card number as a keyless code will not work. To override this disable, just add a new tenant without any name,
and only enter the keyless code in the Apartment Selection screen.
B. Apartment Selection
This screen (far right) is used to set up the information on each of
the tenants in the building. New tenants can be added, and exist-
ing names and codes can be changed. When
using card readers, the keyless entry code fea-
ture can be disabled in the system Parameters
screen. If you want to have a code that can over-
ride this feature, enter a five digit code number in
the Keyless Code box, but do not fill in any other
boxes. That code can be used as a keyless code
even though keyless codes have been disabled.
If the apartment phone line is wired through a
Viking C-3000, the phone number field must start
with a "C".
The list can be sorted according to name, apart-
ment number, phone number, or code numbers
by selecting the "Sort" pull down (near right). Clicking on the Back button will bring up the previous screen "Building Selection", click-
ing on the Next button will bring up the "Data Transmit" screen.
C. Transmitting Data to and from the AES-2005
After the PB-100 dials the phone number of the AES-2005 and creates a link, the AES Remote Screen
(Statistic Info), then the Security Code screen will pop up. If the security code in the AES-2005 is still the
default value enter "8,4,5,4,6,4". If the security code has been changed from default, enter your unique
security code. Once in the Data Transmit screen, use the Security Code selection under the Tools pull
down to change the security code. If this screen is left blank, no code will be required. Keep in mind that
while the PB-100 is linked to the AES-2005, ALL DOOR ENTRY FUNCTIONS ARE HALTED until the PB-
100 hangs up.
1. Data Transmit Screen
The Data Transmit screen (right) is used to control the trans-
fer of information from the P.C. to the entry system. The data
block size and the number of retries can be tailored to fit any
phone line condition. The user has the option of sending all the
records or just sending the records that have been modified in
the previous screen by setting the "Show Changes Only"
check off. If an AES-NET card installed in the AES-2005 and
a local card reader is used, the AES-NET can be programmed
using the Local Card Reader selection of the Tools pull down.
For more information on programming the local card reader,
refer to the AES-NET Technical Practice. To go to the previ-
ous Apartment Selection screen, click on the Back button. To
go on to the audio recording click on the Next button.
The Remote Programming Software is capable of handling infor-
mation on many different buildings. The Building Selection screen
(left) displays the information on each building. This screen also
allows the user to add a new building, or drop an old one. Pressing
the Next button will bring up the "Apartment Selection" screen.
7
Advertisement
Table of Contents
