Frymaster FOOTPRINT PRO SERIES 35 Installating And Operation Manual page 30

4.2.2 Preparation for Use with the Magnasol Filter Assembly
1. Pull the filter pan out from the cabinet
and remove the crumb screen and
Magnasol filter assembly.
The filter pan is equipped with rollers in
rails, much like a kitchen drawer. The
pan may be removed for cleaning or to
gain access to interior components by
lifting the front of the pan to disengage
the front rollers, then pulling it forward
until the rear rollers clear the rails. The
pan cover must not be removed except
for cleaning, interior access, or to allow
a shortening disposal unit (SDU) to be
positioned under the drain.
NOTE:
Refer to Section 4.4 for
instructions on how to disassemble and
reassemble the Magnasol filter screen
assembly.
2. Inspect the fitting on the bottom of the
Magnasol filter assembly to ensure that
the O-ring is present and in good
condition.
3. Inspect the filter pan connection fitting
to ensure that both O-rings are present
and in good condition.
Remove the crumb screen and filter assembly
from the pan. Clean all components with a
solution of detergent and hot water, then dry
thoroughly.
Inspect the filter screen O-ring.
Inspect the filter connection fitting O-rings.
4-5