Operation; Voice Scrambler; Programming - Standard Communications Horizon GX2335S NOVA+ Owner's Manual

To change A and B channel assignments, perform the following steps:
1. Press and hold the A/B key and then press and release the MEM key.
The "A" will blink and dashes "—" will appear on the display.
2. Release the A/B key and set the new channel to be designated
Channel A (or leave the channel unassigned).
3. Press the A/B key once to recall Channel A. Next press and hold the
A/B key and press and release the MEM key. The "b" will blink and
dashes "—" will appear on the display.
4. Release the A/B key and set the new channel to be designated
Channel B (or leave the channel unassigned).

5.14.2 Operation

Pressing the A/B key more than once toggles between channel A and
channel B. Channel A is represented by "A" to the left of the channel
number on the LCD, and channel B is represented by "b". Do not confuse
this "A" with the one that sometimes is displayed to the right of the channel
number (described in the Display section of this Owner's Manual).

5.15 VOICE SCRAMBLER

If privacy of communications is desired, a CVS240 voice scrambler (VS)
can be installed in the transceiver. Contact your Dealer or the SCC factory
to have a CVS240 installed.

5.15.1 Programming

Once a CVS240 is installed in the transceiver, channels to be scrambled
can be programmed as follows:
1. Hold down the LAMP key and turn on the
transceiver.
2. P r e s s t h e C H k e y o r C H A N N E L
SELECTOR knob to set the VS code (000
to 127).
3. Press the MEM key to show the VS
channel setting display. (Press the LAMP
key to return step 2.)
GX2335S Owner's Manual
USA
INTL
CAN
page 19