Operation With Voice Scrambler - Standard Communications Horizon GX2335S NOVA+ Owner's Manual

4. P r e s s t h e C H k e y o r C H A N N E L
SELECTOR knob to select the channel to
be scrambled.
5. Press the MEM key. "MEM" is displayed
on the LCD. The scrambler code is
d i s p l a y e d t o i n d i c a t e c h a n n e l i s
programmed.
6. Repeat steps 4 and 5 to program other channels to be scrambled.
Only one scrambler code can be chosen for all channels programmed.
All channels programmed will have the scrambler code set in step 2.
7. Turn off the transceiver after programming is completed.

5.15.2 Operation with voice scrambler

1. Turn on the transceiver.
2. Select a channel that was programmed for scrambler mode.
3. Hold down the MEM key 1 second to turn
the scrambler on. "VS" and the VS code
will be displayed to indicate that the
scrambler is activated.
4. Monitor the channel before transmitting.
5. Transmit the voice message. The signal sent will be scrambled.
The transmitted message cannot be reproduced at the receiving end if
the receiving transceiver does not have a Standard Communications
Corp. voice scrambler installed and programmed. The transmitting and
receiving ends must also have matching VS codes.
6. Hold down the MEM key to turn the
scrambler off.
page 20
NOTE
Owner's Manual
USA
INTL
CAN
USA
INTL
CAN
USA
USA
USA
MEM
MEM
GX2335S