Priority Scanning; Weather Alert - Standard Communications Horizon GX2335S NOVA+ Owner's Manual

5. To start scanning, press the SCAN key.
Scanning will proceed from the lowest to
the highest programmed channel number
and will stop on a channel when a
transmission is received.
6. To stop scanning, press the SCAN, 16/9, WX, or PTT key.
7. To DELETE a channel from the transceiver's memory, press the MEM
key again while the memorized channel is displayed on the LCD.
"MEM" will be deleted from the LCD.

5.8 PRIORITY SCANNING

1. The following channels can be set as the priority channel; 16, 09, and
A or B preset channels. To set the priority channel, press and hold the
16/9 key and press the MEM key. The channel will change from 16 to
09 to A or B preset channel with each press of the MEM key. The
displayed channel is set to the priority channel.
2. For priority scanning, hold down the SCAN key at least 1 second
during normal scanning, Scanning will proceed between the
memorized channels and the priority channel. The priority channel will
be scanned after each programmed channel.
3. For example, channels 06, 07, 08 are memorized in the transceiver's
memory, Priority scanning will proceed in the following sequence:
CH06
3. Even when the transceiver stops and listens to the signal of a
programmed channel, the transceiver will DUAL WATCH between this
channel and the priority channel.

5.9 WEATHER ALERT

In the event of extreme weather disturbances such as storms and
hurricanes, the NOAA (National Oceanic and Atmospheric Administration)
sends a weather alert accompanied by a 1050 Hz tone and subsequent
weather report on one of the weather channels. The transceiver is capable
of receiving this alert if the following is performed:
page 16
NOVA+
Priority
CH07
channel
Owner's Manual
RAM MIC
Priority
CH08
channel
Priority
channel
GX2335S