Operation; Initial Procedure; Battery Pack Installation - Standard Communications Horizon HX255S Owner's Manual

4

4.1 INITIAL PROCEDURE

Never key the transceiver without an antenna connected. Damage
may occur to the transceiver. Do not operate the transceiver while
charging.
1. Install the belt clip on the transceiver if desired. Use the 2 phillips-
head screws included with the clip to mount the clip to the back of
the transceiver.
2. Install the nylon carrying strap on the belt clip if desired. The steel
ring on the strap attaches to a hole on a tab protruding from the belt
clip.
3. Install the battery pack on the transceiver. (see figure 3 and
section 5.2)
4. Install the antenna to the transceiver. (see figure 4)
5. Turn the POWER /VOLUME CONTROL knob clockwise to turn the
transceiver on.
Water resistance of the transceiver is assured only when the
battery pack and antenna are attached to the transceiver.
Page 8
NOTE
NOTE
Figure 3. Battery Pack Installation
Owner's Manual

OPERATION

Turn the battery lock
screw clockwise 3 or 4
turns to tighten.
HX255S