Scanning; Priority Scanning - Standard Communications Horizon Eclipse+ GX1250S Owner's Manual

5.6 SCANNING

1. Adjust the SQUELCH CONTROL until the background noise
disappears.
2. Select the desired channel to be scanned using the UP or DN key.
3. Hold down the SCAN key until "MEM" is displayed.
4. Repeat steps 2 and 3 for the channels to be scanned.
5. To start scanning, press the SCAN key. Scanning proceeds from
the lowest to the highest programmed channel number and stops on
a channel where a transmission is received.
6. To stop scanning, press the 16/9, WX, SCAN key, or PTT switch.
7. To DELETE a channel from the transceiver's memory, hold down the
SCAN key while the memorized channel is displayed. "MEM" is
deleted.

5.7 PRIORITY SCANNING

Emergency channel 16 can be set as the priority channel for scanning
by performing the following:
1. Turn off the transceiver power.
2. Press and hold the SCAN key and turn the power back on. A "p" will
be shown to the left of "16" on the display to indicate that priority
scan is enabled.
To scan or priority scan, 2 or more channels must be memorized in
scan memory. See section 5.6 in the Owner's Manual.
3. To start scanning, press the SCAN key. Scanning will proceed
between the memorized channels and priority channel 16.
4. For example, channels 06, 07, and 08 are memorized in the transceiver's
memory, priority scanning will proceed in the following sequence:
CH06
GX1250S
Priority
Channel CH07
16
Owner's Manual
NOTE
Priority
Channel
16
Priority
CH08 Channel
16
Page 13