Table of Contents
Advertisement
Quick Links
Installation Instructions
for Frontload Washers
Inside.......................................
Washer Dimensions...........................................................
Before You Start................................................................
Installation.........................................................................
Installer Checklist ..........................................
Date Purchased _____________________________
Model Number _____________________________
Serial Number ______________________________
Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com.
Keep these instructions for future reference.
(If this machine changes ownership, this manual must accompany machine.)
2
2
3
Back Cover
www.comlaundry.com
Part No. 802750R2
May 2011
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alliance Laundry Systems 802750R2
Summary of Contents for Alliance Laundry Systems 802750R2
-
Page 1: Installation Instructions
Date Purchased _____________________________ Model Number _____________________________ Serial Number ______________________________ Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com. Keep these instructions for future reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 802750R2 May 2011 www.comlaundry.com... -
Page 2: Washer Dimensions
Water is used during testing at the manufacturer. FLW2045N NOTE: Install dryer before washer. This allows Safety Glasses room for attaching exhaust duct. Wood Block Wrench Screwdriver Pliers Socket Wrench Level Figure 2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802750... -
Page 3: Step 1: Position Washer Near Installation Area
Place a level on the cabinet top and check if the washer is level from side to side and front to back. NOTE: Level must rest on raised portion of top panel. Refer to Figure 3. 802750 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... - Page 4 NOTE: Water pressure under 20 pounds per square inch (138 kPa) will cause an extended fill time in the washer and may not properly flush out the detergent dispenser. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802750...
- Page 5 All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. 802750 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 6: Step 4: Connect Drain Hose To Drain Receptacle
Refer to Figure 7. Beaded Strap (tape if necessary) NOTE: End of drain hose must not be below 24 in. (61 cm). Figure 8 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802750... -
Page 7: Step 5: Remove The Shock Sleeves And Shipping Brace
Save materials for use whenever the unit is moved. Reinstall front access panel. FLW2166N FLW2166N Figure 10 FLW2124N FLW2124N Shock Sleeves Motor Mount Hooked End of Shipping Brace Bolts and Lockwashers Figure 9 802750 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 8: Grounding Information
W518 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802750... -
Page 9: Step 8: Check Installation
Do not cut or remove the grounding prong from this plug. W213 NOTE: The wiring diagram is located in the control hood. 802750 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 12: Installer Checklist
• Plug in the Washer. Cold Valve Connection COLD Plain Washers CHECK FLW2054N Hot Valve Connection CHECK FLW2054N D254I D254I • Connect Drain Hose to Drain Receptacle. FLW1992N FLW1992N CHECK © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the 802750R2 and is the answer not in the manual?
Questions and answers