Table of Contents
Advertisement
Quick Links
Installation Instructions
for Frontload Washers
Inside.....................................
Washer Dimensions...........................................................
Before You Start................................................................
Installation.........................................................................
Installer Checklist..............................................................
Date Purchased ________________
Model Number ________________
Serial Number _________________
Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com.
Keep these instructions for future reference.
(If this machine changes ownership, this manual must accompany machine.)
2
2
3
Back Cover
www.comlaundry.com
Part No. 802749R1
July 2008
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alliance Laundry Systems 802749r1
Summary of Contents for Alliance Laundry Systems 802749r1
-
Page 1: Installation Instructions
Date Purchased ________________ Model Number ________________ Serial Number _________________ Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com. Keep these instructions for future reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 802749R1 July 2008 www.comlaundry.com... -
Page 2: Washer Dimensions
Water is used during testing at the manufacturer. Safety Glasses Wood Block NOTE: Install dryer before washer. This allows Wrench room for attaching exhaust duct. Screwdriver Pliers Socket Wrench Level Figure 2 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 3: Installation
WARNING To avoid personal injury, recommended inlet water temperature should be no higher than 125° Fahrenheit (51° Celsius). W709 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 4: Step 3: Connect Drain Hose To Drain Receptacle
All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 5: Standpipe Installation
Drain Hose Standpipe - 2 in. (5.08 cm) or 1-1/2 in. (4 cm) Beaded Strap (tape if necessary) Beaded Strap Fill Hoses Figure 5 Figure 6 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 6: Step 4: Position And Level The Washer
Place washer in position on a solid, sturdy and level floor. Installing the washer on any type of carpeting, soft tile, a platform or other weakly supported structures is not recommended. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 7: Step 5: Remove The Shock Sleeves And Shipping Brace
FLW2124N FLW2155N FLW2124N Shock Sleeves Figure 10 Motor Mount Hooked End of Shipping Brace Bolts and Lockwashers Figure 9 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 8: Step 7: (Supply Injection Models Only) Connect External Supplies To Washer
TERMINAL SW016 BLOCK NOTE: Normally Open Contacts. Contacts Close to Start Chemical Injection. Maximum Load Connection per Contact: 1A @ 120VAC/240VAC 801653R1 FLW2028N Figure 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 9: Control Function Test
DO NOT use an extension cord or an DRY2022N adapter to connect the washer to the electric power source. Ground W082 Neutral Side Round Grounding Prong Neutral Figure 13 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 10: Step 9: Check Installation
NOTE: Have a qualified electrician check the polarity of the wall receptacle. If a voltage reading is measured other than that in Figure 13, the qualified electrician should correct the problem. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802749... -
Page 12: Installer Checklist
Installer Checklist Fast Track for Installing the Washer (Refer to the manual for more detailed information) • Position Washer Near • Remove the Shock Sleeves Installation Area. and Shipping Brace. FLW2124N CHECK CHECK FLW2124N • Connect Fill Filter • Wipe Out Inside of Screens Hoses.
Need help?
Do you have a question about the 802749r1 and is the answer not in the manual?
Questions and answers