Timer Recordings - Daewoo DCR-9120 Owner's Manual

Timer Recordings

TIMER RECORDINGS USING ShowView
For timer recordings, clock, date, and stations must be set correctly.
Load a cassette with its safety tab in place and with sufficient free space for the recording.
Call the ShowView menu by pressing PROGRAM on the
remote control.
1
From your TV magazine, type in the number next to the programme you
want to record ...
... and confirm.
Decide if you want to record "ONCE", "WEEKLY" or "DAILY"...
2
... and confirm.
If you wish to make changes:
Move to the position you want to change using the [œ/√] buttons.
3
Change the setting using the [.../†] or [number] buttons. If all setting
are ok, press [ok], till you see "OK: CONFIRM" in the bottom line.
Confirm.
Switch your player off.
• VPS/PDC is a service provided by some stations to enable you to perform timer recordings precisely even if
the broadcaster delays the start time of the programme slightly. The time you enter is the VPS/PDC time so
must be correct. Not all stations offer VPS/PDC, in which case the player will start at the time you enter and
not the actual start time of the programme.
If you wish to start recording at a specific time without it being adjusted by the VPS/PDC system in the
event of a delay, switch VPS/PDC off otherwise the player will not record.
• If you don't have the ShowView numbers see next page for the normal timer.
• If you have made a mistake, move back to the relevant position with the [œ] button and change the setting.
• If there is no programme location displayed under "PR" in the change menu, the player doesn't yet know
the location number for the programme you want. Type it in and this will be stored for last recordings.
• If you wish to record from a satellite receiver, select under "PR" the satellite programme location or AV (1/2)
(depending on the connection with the antenna cable or the SCART-cable). Leave the satellite tuner
switched on and to the programme you want.
• Should programming overlap, you get a warning.
• To cancel the recording press the
• ShowView is a trademark applied for by Gemstar Development Corp.. The ShowView system is
manufactured under license from Gemstar Development Corporation.
50
button (stop) more than 5 seconds.
SHOWVIEW
83077----
0-9:SHOWVIEW NUMBER
œ : CORRECT
OK:CONFIRM SETUP:END
HOW OFTEN DO YOU WANT
TO RECORD THIS PROGRAM?
ONCE
WEEKLY(ONCE A WEEK)
DAILY(MON-FRI)
DAILY(MON-SAT)
DAILY(MON-SUN)
.../†:SELECT
OK:CONFIRM SETUP:END
TIMER PROGRAM (ONCE)
PR 03
START TIME 21:20
END TIME 22:20
START DATE 14/06(SAT)
TAPE SPEED SP
VPS/PDC ON
.../†:SELECT (AV1/AV2)
0-9 : SETUP (PR)
œ/√:
CORRECT
OK:CONFIRM SETUP:END