Connections - Daewoo DCR-9120 Owner's Manual

Connections

If you are using a SCART cable, select the AV input on the TV to see the picture from the player.
If you are not using a SCART cable, select the button number on the TV reserved for video input to see the
picture from the player.
To the TV via antenna cable (if you are not using a SCART cable)
If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just tune
the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to ensure the best pictures and
sound.
Once you have carried out the steps in "Connecting up the player", switch on your
1
TV.
Press the [OK] button of the player's remote control longer than 5 seconds to call
the player´s test picture.
Tune the TV to the test picture using the channel pre-set functions of your TV as
described in its manual.
When you have found the test picture, store it under the button number on your TV
for player input.
Press the [OK] button of the player's remote control again longer than 5 seconds to
release the test picture.
• If the quality of the test picture transmitted to the TV is poor due to interference
2
caused by a station transmitting on channel 52, you can tune the player to a
different transmitting channel. Find a free channel between 21 and 69 on your TV.
Call the player's "SETUP" choose "VCR SETUP" then "RF OUTPUT SET".
Type in the free channel.
Store and exit.
• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help (refer to the
TV manual).
• Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.
30
RF OUTPUT SET
CH 52
0-9:SELECT (21-69)
OK:CONFIRM SETUP:END