Removing The Main Board - NEC VERSA P600 Disassembly Manual

Removing the Main Board

To remove the Main board, first open the Top Cover (see
DC/DC board (see
1. Remove the screws holding the main board in place as shown in Fig. 33
2. Disconnect the VGA connector from the base as shown in Fig. 34
3. Lift the main board out of the system and put it aside (Fig. 35 ).
Removing DC/DC board) then perform the following steps:
A
Fig. 33 Removing the main board screws
Fig. 34 Disconnecting the VGA connector
NEC Versa P600 Disassembly Manual
Removing the Top
A
B
Cover), remove
A = M2x5
B = M2.5x8
M2.5x10 silver
Silver
Silver
Page 21