Removing The Lcd Panel - NEC Versa E6000 Disassembly Manual

Removing the LCD Panel

To remove the LCD panel, first remove the LCD module (see
then perform the following steps:
1. Use a pin to remove the rubber cover on the LCD module as shown in Fig. 17
2. Remove all screws as shown in Fig. 17 and remove carefully the LCD cover.
Fig. 17 Removing the rubber covers & screws on the LCD Module
3. Release the inverter board by remove the screw and disconnect all connectors as shown
in Fig. 18
NEC Versa E6000/PB Easy Note G5 Disassembly Manual
Fig. 18 Removing the Inverter Board
Removing the LCD Module),
M2.5x7 Silver
M2x4 Silver
Page 14