4
SETTING AND FASTENING THE DOOR (CONTINUED)
Frame Screw Method:
Note: If using installation clips, proceed to step 4N.
Interior
Exterior
L.
M.
holes in the retainer into the sill support or wood blocking, then apply sealant to the
holes and insert a screw into each hole as specified below.
Aluminum sill support: 9/64" pilot holes, #10 x 3/4" thread cutting screws (provided).
Wood blocking: 1/8" pilot holes, #10 x 2-1/2" flat head corrosion resistant wood
screws (provided).
Masonry floor: 3/16" x 1-3/4" concrete screws. Pilot drill per screw manufacturer's
recommendations.
Installation Clip Method:
N. Fasten the door to the opening by driving two #8 x 1-1/4" corrosion resistant screws into
the pre-punched holes in the clips. If the clips are bent and fastened to the interior stud/
block, install the screws as close to the bend as possible.
Note: DO NOT shim above the door. For masonry openings use two 3/16" x 1-1/2"
masonry screws per clip. Pre-drill the masonry before attempting to drive the screws in.
O.
threshold in to the floor.
Note: For concrete floors, use masonry screws a minimum size of 3/16" x 3-1/2".
3G
4L
Fixed Panel
in the bottom of the door frame, as indicated above.
by drilling pilot holes through the remaining
4N
Threshold
4M
3H
through the holes in the