Setting And Fastening The Door - Pella 81CM0100 Installation Instructions Manual

3
PREPARE THE DOOR FOR INSTALLATION (CONTINUED)
F. Doors using Installation Clips: Install
installation clips. Place the clip so that the
lip is facing up and against the flush flange,
at the locations shown in the placement
diagram. Secure the clip by driving #6 x
5/8" corrosion resistant screws through the
outer two holes of the three holes shown.
G.
extending 6"
down each jamb. Place
the tape starting on
the aluminum cladding
and extending onto the
wood frame.
4

SETTING AND FASTENING THE DOOR

A. Dry fit the door into the opening.
Note: If the new door frame is deeper than the existing door frame, it will be
necessary to cut the interior flooring material back to allow the door flush flanges to
contact the existing aluminum door frame.
B. From the exterior, set the door into the opening. Set the sill of the door on the sill
panel and tilt the door into position.
C. Insert shims around the door temporarily while you verify that the door will fit into the
opening and that the door flanges will overlap the stucco or existing aluminum door
frame by a minimum of 1/2" on all sides.
REMOVE THE DOOR FROM THE OPENING
D.
of the interior sill pan lip. This bead should also continue up the corner of the sill pan
at each end, sealing the vertical joints of the sill pan and up 6" onto each jamb side of
the rough opening. The second bead should be approximately 1/2" from the exterior
edge of the frame wall, running from jamb to jamb with a 2" break in the middle of the
opening. Place a third sealant bead 1/4" from the exterior edge of the flat portion of the
sill nose or the sill pan. Start and stop this sealant line 1" from each jamb.
1 "
1/2"
1 st B e a d
2 n d B e a d
6 "
3 rd B e a d
3F
3G
Pella SmartFlash Tape
Place the first beads sealant 1/2" in front of the base
4D
#6 x 5/8" corrosion
resistant screws
Lip
6"
Application without
sill pan
1 st B e a d
2 n d B e a d
6 "
3 rd B e a d
1 "
Pella
SmartFlash
Tape
6" from end
6"